NEC SL2100 Hardware Manual page 190

ISSUE 4.0
Section 2 PROGRAMMING MODE
2.1 Entering the Programming Mode
The installer/system administrator can enter to the system programming mode from the Display Type
Multiline Telephone. (A maximum of two users can enter mode at the same time)
In a newly installed system, use extension port 1.
1. Press Speaker key. (Do not lift the handset)
2. Dial # * # * .
11-10 WED 1:49PM
200
Menu Dir VM:00 CL:00
Figure 3-4 Entering Programming Mode Display 1 (12TXH/24TXH-B1)
3. Dial the system password, then press Hold key to enter the Program Mode.
Password@@@@@@@@
Figure 3-5 Entering Programming Mode Display 2 (12TXH/24TXH-B1)
For the details of programming, refer to the SL2100 Programming Manual. (separate issue)
2.2 Exiting the Programming Mode
1. Press Mute key several times to return to the "Program Mode" Screen.
10-01-
Time&Date Setup
back
Figure 3-6 Exiting the Programming Mode Display 1 (12TXH/24TXH-B1)
2. Press Speaker key to exit.
Base
Figure 3-7 Exiting Programming Mode Display 2 (12TXH/24TXH-B1)
The system automatically saves the customer data to the memory which is backed up by lithium
battery.
PROGRAMMING MODE
Sys Config
|01
Select
Program Mode
Service OP1 OP2
Password
Program Mode
Base
Service OP1 OP2
Program Mode
Base
Service OP1 OP2
11-10 WED 1:49PM
200
Menu Dir VM:00 CL:00
SL2100
188