NEC SL2100 Hardware Manual page 142

ISSUE 4.0
For detailed information on daisy-chain layout and configuration, contact your installer or refer to the
DTL-RPT-1 Administrator's Guide.
6.2.1 Setting Up Your Repeater
Before installing the repeater, you must activate the repeater mode on your base and then register the
repeater to the base and any handsets. Before you start the registration process, be sure you have:
• A working base
• A working handset registered to that base
• Any repeaters you want to register to this base (you must complete the registration process
separately for each repeater)
• At least one of the AC adapters supplied with the repeaters
Use ONLY the power adapter that came with your repeater. A different power adapter may cause an
electrical hazard or damage the repeater.
6.2.1.1 Changing the Telephone System PIN
Before you start the registration process, you must reset the system PIN of your telephone to 0000
(consult the manual that came with your base for more information). After you reset the PIN, make
sure to register the handset you used back to the base station.
6.2.1.2 Automatic Registration
The repeater seeks out the base with strongest DECT/GAP signal and automatically registers to that
base.
1. Make sure the repeater is powered off (i.e., the AC power adapter is not connected).
2. Set the base in registration mode. (Consult the owner's manual that came with your base station
for more information.
3. Use the AC adapter to connect the repeater to a standard 120 V AC outlet. (Do not use a power
outlet controlled by a wall switch.) The LED on the repeater flashes briefly, then remains on and
steady.
If the LED continues to flash, register the repeater again.
The repeater is now registered to this base and is ready to use.
You can safely disconnect the power and move the repeater to the selected location; the repeater
stays registered to the base.
INSTALLING WIRELESS DECT TELEPHONES
Figure 2-145 Daisy-Chain Layout
SL2100
140