Hitachi IJ RX2-SD160 Instruction Manual page 124

Print specifications
Message name [ ]
1st screen
Product speed matching
Print Target width (mm 0〜9999)
Actual Print width (mm 0〜9999)
Speed compensation
Print Target width
12
● Enter "Print Target width" in mm for "Auto".
Input the length of the place over which the print target is detected.
● The Print Target width setting range is from 0 to 9999.
● If "Print Target width" is not entered, the print is made with the same interval as when the Speed
matching function is not used.
Actual Print width
13
● Enter "Actual Print width" in mm for "Auto".
● The Actual Print width setting range is from 0 to 9999.
● The value for "Actual Print width" must be smaller than "Print Target width".
● If "Actual Print width" is not entered, the print is made with the same interval as when the Speed
matching function is not used.
Screen switching
4-75 ●Set the print specifications
[Stop ]
2nd screen 3rd screen
None Encoder Auto
００６０
００３０
Disable
Enable
The place over which
the print target is detected.
3rd screen of "Print specifications" screen
Print specifications
Message name [ ]
1st screen
Target sensor timer （1/10sec 0: none 1〜999）
Target sensor filter
Setup value
Ink Drop Charge Rule
Standard(single : It prints by the Single scan or Interlaced.
scan/interlaced)
2015.07.07 12:45
Com=0
M
Startup
Manual
HOME
Actual Print width
13
ABC
Print Target width
12
[Stop ]
2nd screen
3rd screen
０００
Until end of print.
Time setup
(ms 0〜9999)
００５０
Standard(single scan/interlaced)
2015.07.07 12:45
Com=0
M
Manual Startup
HOME
Edit
message
Print
format
Back