Hitachi IJ RX2-SD160 Instruction Manual page 31

Confirm that the ink stream is at the center of the gutter.
5
● Check the position of the ink stream from the sides and top of the print head as shown in the figure
and confirm that it is in the center of the gutter.
Side direction
● If the ink stream is not at the center of the gutter, perform step 1 and stop the ink injection. After
that, take action in accordance with Technical Manual "6.4 How to correct ink stream bending and
nozzle clogging".
● Wear protective gear (goggles and mask) when checking the position of the ink stream.
● If you should get ink or makeup in your eyes or mouth, immediately wash with warm
water or water and see a doctor.
● When ejecting the ink, do it after confirming that there is no one in the ejection
direction.
(Operate with the end of the print head inserted in a beaker, etc.)
Install the print head cover.
6
●Wait until the status changes to "Ready".
●If the "Cover open" error was displayed, press the Close .
Input the print target detection signal and check the printing state.
7
(See "3.1.1 Start operation".)
Ink stream
Upper direction
Gutter
WARNING
Gutter entrance diameter
The ink stream
should be positioned
at the center of the
gutter inlet.
●Start operation 3-8