Hitachi IJ RX2-SD160 Instruction Manual page 145

3 Reverse print
● Set for the print position at character orientation 1 and 3 setting.
right-justified
left-justified
(Example)
Results when print contents of
[1 2 3 4 5 6 7 8 9 0]
[ABC]
are printed in character orientation 1.
right-justified
left-justified
● Columns with items with double width size 5 to 9 set are always printed right-justified.
● This setting functions the same as reciprocating printing reverse direction printing
● Format setup is free layout, it is printed as set the print items.
4 Print signal type (Optional on RX2-B)
● Sets whether the IJ printer print output signal is made print.complete or print.-in-progress.
print.complete
print.-in-progress
Print Data Changeover In Progress error
5
● Sets whether to issue an error or not at print timing while Print data changeover is in progress.
● Error is not issued when set value is "Disabled", setup of Print data recall or Character input are
modified and overlaps print timing.
● If the print target sensor data is input before the print data changeover in communication is complete,
and error is not issued and the data prints before the changeover.
Function
Print format, Character input(*1),
Calendar condition, Print specification(*2),
Print data recall
Count condition, Character input
(Character data in count block)
Adjust print parameters, Save message,
Count reset, Operation management,
Date/time setup(Current time)
User environment setup, Date/time setup
(except current time), Communication
environment setup, Excitation V update,
Print specification(Speed compensation,
Speed compensation fine control)
(*1) Except character data in count block.
(*2) Except Speed compensation and Speed compensation fine control.
● When in Ready status, user pattern can not be saved to existing pattern number.
● When in Ready status, the edit standard pattern function can not be run.
Aligns the print position along the right margin when printing line 2 and
subsequent lines.
(The print position is different for character orientation settings 0 and 2.)
Aligns the print position along the left margin when printing line 2 and
subsequent lines
(The print position is the same for character orientation settings 0 and 2.)
1 2 3 4 5 6 7 8 9 0
A BC
1 2 3 4 5 6 7 8 9 0
ABC
Output for a fixed time after printing is complete.
Output while the IJ printer is printing.
Specification of Print Data Changeover In Progress error
No error and changeover
Set value of Print Data Changeover In Progress
Disabled
Fault "Invalid Count Data Change Timing"
No error and changeover
Fault "Invalid Data Change Timing"
Enabled
Fault "Print Data
Changeover In Progress"
●Set the user environment 6-3