Hitachi IJ RX2-SD160 Instruction Manual page 207

No. Message
35 Model-key fault
37 Language key fault Language-key recognition failed.
(2) Faults that do not invoke ink stoppage
No. Message
35 Model-key fault
37 Language key fault Language-key recognition failed.
Print Data
27 Changeover
Error C
Print Data
28 Changeover
Error M
Free Layout
38
Printing Failure
External
40 Communication
Error nnn
Ink Drop Charge
42
Too High
Barcode Short On
43
Numbers
44 Shutdown Fault
45 Count Overflow
Invalid Data
46
Change Timing
Invalid Count Data
47
Change Timing
Invalid Print Start
48
Timing
Meaning of message
Model-key recognition failed.
Meaning of message
Model-key recognition failed.
The print data change procedure was
incomplete.
The print data change procedure was
incomplete.
The free layout printing was aborted while
the message was printing.
The serial communication port had a data
error.
The charge sensor detects a high drop
charge.
The number of characters for the selected
barcode type is insufficient.
The shutdown process failed.
The calculation result of the count
multiplier overflowed.
A print operation was requested while the
print data was being changed.
A print operation was requested while the
print data was being changed.
The print target detection signal for the next
target arrived during the data was being
changed.
Remedy
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
Remedy
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
● Check the data entered
● Check the data entered
● Delete some print items or
decrease the setting of the ink
drop use. ( 4.8.6)
● Note the error code and see
that no more error occure.
( Technical manual 5.7)
● Clean the gutter, deflection
electrode, and its
surroundings.
● Adjust the excitation V-ref. to
make sure that the ink drops
are well made.
( Technical manual 6.11)
● Adjust the ink pressure.
● Check that the ink stream is
correctly retracted.
( Technical manual 6.10)
●Configure the number of
( 4.8.5) characters for
barcode to appropriate value.
( Technical manual 9)
●Turn the printer power OFF by
main switch.
Contact your nearest local
distributor.
● Change the count multiplier
setting.
● Change of either data change
or print start.
● Change of either data change
or print start.
● Change of either data change
or print start.
●On-screen message descriptions 9-5