Shutdown (No-Cleaning Stop) - Hitachi IJ RX2-SD160 Instruction Manual

1.4 Shutdown (no-cleaning stop)

When you press the Shutdown
completing its automatic nozzle cleaning sequence. If you repeatedly activate the Shutdown
operation, excessive makeup will enter the printer, thereby thinning the ink or producing an unduly high ink main
tank solution level. If it is absolutely necessary to repeatedly stop the printer operation, use the following
procedure.
The no-cleaning stop procedure works even while the startup sequence is
being executed.
(The Shutdown button is inoperative during the startup sequence.)
*1: Do not use the Shutdown to stop operation more than two successive times.
*2: When operation was stopped using No-cleaning stop , if left in that state, the ink will become stuck in the
nozzle and cause ink stream bending, nozzle clogging, and printing disturbance. Apply makeup to the
orifice plate to wash it within 30 minutes after a stop to cause the ink to eject once again.
1 Press the Manual
(The Manual
M
Manual
2015.07.07 12:45
Com=0
M
Manual Startup
＝＝＝＝＝
Start
The current message is
printing
printed.
2 Press the No-cleaning stop within the control menu.
2
An ink stop confirmation message appears.
＝＝＝＝＝
Shutdown will stop the ink jet.
Solution To stop the ink jet, press <OK>.
OK
Press the OK .
3
on the upper right-hand corner of the screen, the printer stops after
Shutdown
.
M
Manual
is displayed commonly on all the screens.)
Manual
Common to all screens
Manual Control Menu
No-cleaning
stop
Standby
Shutdown Process Confirmation
＝＝＝＝＝
Stops ink ejection
without cleaning.
No deflection voltage is
applied. The printer
status becomes Standby.
Cancel
＝＝＝＝＝
Close
to stop an
Shutdown
No-cleaning stop
●Shutdown 1-3