Printing Results - Hitachi IJ RX2-SD160 Instruction Manual

* The conditions where "Character width" can be set to "0" are described in Table below.
No.
1
2
Print specification
3
4 User environment setup
When "Character width" is set to "0" and "
(i) The conveyor speed is detected by the encoder and the character width is set and fixed by that
speed detected. If the print object is slipped on the conveyor or its transfer speed fluctuates
substantially while the print object is passing the object sensor and the printing is completed,
the print start delay variation or the character width variation is expected. Please be sure to
conduct test printing and confirm whether there is any variation of print start delay or the
character width. If the substantial variation is observed, please set the Character width to 2 or
more.
(ii) The item on "Adjust printer parameters" screen are not available.
(iii) The conveyor speed is caculated print by print. Therefore "Print start delay".
(iii) The conveyor speed is caculated print by print. Therefore "Print start delay" will become
longer by 30 scans than that of "Encoder" due to its calculation time.
(iv) The number of print formats will be four (4) or less.
● For rotary encoder wiring and setup, see the Technical Manual "4.3.2-1 Rotary encoder
specifications, wiring and switch setting".
Character orientation
4
● Printing direction of characters can be set.
● Settings and print results are as shown below.
Setting
0 : A B C
→
1 : A B C
←
2 :
←
3 :
→
Printing method
5
● Two printing methods are selectable: "single scan", "interlaced" and "mixed".
● A printing method will be automatically selected in accordance with the print format setup and
the ink drop charge rule.
Icon
Single
Standard (Single scan)
scan
Standard (Interlaced),
Inter-
Dot mixed interlaced
laced
Mixed single scan and interlaced
Mixed
Setup screen
Product speed matching
High speed print mode
Print data changeover error
Direction of transport
a←
→b
a←
→b
a←
→b
a←
→b
Display of Printing method
Ink Drop Charge Rule Classification
Items
Ink drop use
Product speed matching
a

Printing results

A B C 1 2 3
3 2 1 C B A
3 2 1 C B A
A B C 1 2 3
A B C 1 2 3
Example of setting "0:ABC→"
and Direction of transport "a".
A B C 1 2 3
When there are multiple printing lines,
multiple lines are printed in turn.
Multiple lines are printed at the same
time.
Printing is done while switching
between single scan and interlaced for
each column.
Setting
Encoder
1
"HM"
"Enable"
" is set to " ".
Encoder
Direction of transport
b
Printing method
●Set the print specifications 4-72