Hitachi IJ RX2-SD160 Instruction Manual page 146

6 Char. Size menu
● Sets the size of the characters used.
● The following can be set:
Char. Size menu 1
Char. Size menu 2
7
Excitation V-ref. warning
● When the current ambient temperature and the standard ambient temperature (ambient temperature
when Excitation V-ref. value was updated) exceeds a certain level, the alarm "Excitation V-ref. Review"
occurs.
This setting enables/disables that function.
● Setup of enable/disable differs depending on the ink type.
Print characters one by one
8
● Prints only 1 character for each print target detection input.
● Prints one character at a time from the head of the print contents and returns to the head when the end is
reached.
(Printing example) Print contents [ABCDEFGH], Character orientation 0
● Shows the conditions which enable the 1 character print function. When the conditions are not
satisfied, all the set print contents are printed by print material sensor input.
No.
1
2
3
4
5
6
7
● When printing midway through the print contents, when any of the following occurred, printing is
repeated from the first character of the print contents.
No.
1
2
3
4
● The calendar is not updated between printing of the first to last characters of the print contents.
Printing is done with the date and time of the printing of the first character.
9
QR Code printing (RX2-S only)
● The direction of the print of the QR code / Micro QR code is set. Please refer to Technical Manual
"9. APPENDIX Barcode, 2-dimensional code" (
10
Month 3-digit code handling (Optional on RX2-B)
● Sets the content to be printed when transmitting the Month 3-digit code by print contents transmission.
Please refer to Technical Manual "5.4 Code Tables, (7) Calendar character code" (
Numeric
JAN,FEB,--
6-4 ●Set the user environment
5×8, 5×7
9 8, 9
× ×
Print target detection
Print
1 character print conditions (All the conditions must be satisfied.)
The setting item "Print characters one by one" shall be set to "Enable".
All print items are 1 line setting.
The character size of all the print items is the same.
No count item.
No bar code item.
Bold 1 to 4 is set.
Format setup is not free layout.
Conditions which return the character to be printed to the start character
When the state changed (Standby→Ready, Ready→Fault, etc.)
When message was selected
When the message was changed and Apply was pressed
When print data was updated by external communications, external signal,
reciprocative printing signal, etc.
Print with numbers. (001, 002, 003...)
Substitute with alphabetic characters and print.
(JAN, FEB, MAR...)
7
↓ ↓ ↓ ↓
A B C G H A B
Condition
Condition
9-4) for details.
↓ ↓ ↓
5-46) for details.