Hitachi IJ RX2-SD160 Instruction Manual page 129

4.14.2 Set repeat printing
(1)Overview
● This is set to print the same print description continuously.
● Set the "Repeat intervals" and "Repeat count" for repeat printing.
● Repeat printing can not be used when setting "Auto" on "Product speed matching".
1
Repeat intervals
● The print target size can be specified.
● This setup is to be performed when the print target is transported while it is in close contact.
● After setting in character units or mm units, fine adjust in scan units.
● When you want to input in mm units, input "Line speed".
● Perform the following calculations for repeat intervals setup purposes.
(i) On an individual scan basis
(1-digit character width × number of digits - trailing character correction value)
× (print target size/all-digit print width)
(ii) On an individual character basis
Number of digits × (print target size/all-digit print width)
● 1-digit character width = (horizontal character size + inter-character space)
width increase setting
● Trailing character correction value = inter-character space
setting + 1
(Example) Print target size: 64 mm; all-digit print width: 25 mm;
● Round off the calculation results to the nearest whole number.
Print target
Repeat count
2
● You can preset the number of repeats.
● If repeat printing is not needed, set the number to "0".
● Printing is performed in accordance with the repeat printing mode setup.
● The relationship between the repeat printing mode and the count is as stated below.
Mode
Signal ON
period
OFF - ON
transition
number of digits: 6; character size: 5 × 7 dots; inter-character space: 2 dots
● On an individual scan basis
((5+2)×1×6-(2×1+1))×(64/25)=99.84→100
● On an individual character basis
6×(64/25)=15.36→15
Repeat intervals
2 to 9998
Printing is repeated a preselected
number of times at predefined
intervals while the print target is
detected.
Printing is repeated a preselected
number of times at predefined
intervals once the print target is
detected.
×
Print target
Setting
Repeat printing is performed
while the print target is detected.
Once the print target is detected,
repeat printing is performed until
it is aborted.
character
×
character width increase
9999
●Set the print specifications 4-80