Adding An Ats - Huawei FusionPower6000 Maintenance Manual

FusionPower6000
Maintenance Guide
Step 2 Choose Monitoring > Power Distribution, click the corresponding transformer,
and set relevant parameters on the Running Parameters tab page.
----End

7.9.2.2 Adding an ATS

Step 1 Add an ATS.
1.
2.
3.
Issue 02 (2022-07-18)
– If the connection fails, check whether the device is properly connected to
the ECC800-Pro, whether the device and ECC800-Pro are running
properly, and whether the parameter settings are consistent with the
device parameters.
NO TE
Ensure that Detail model is correctly set. Otherwise, the FusionPower6000 layout in the
app and management system will be affected.
Log in to the ECC800-Pro WebUI as an administrator.
Add an ATS.
Table 7-13 Adding an ATS
Path Parameter
Choose Device
System Attribute
Settings >
Device Type
Device
Managemen
t and click
Add Device.
The
parameters
for adding
devices are
displayed.
Connect To
Communicati
ons Port
Device
Address
Click Test Connect to check whether the ATS is properly connected to the
ECC800-Pro.
Copyright © Huawei Digital Power Technologies Co., Ltd.
Setting
Select ATS from the drop-down list box.
Select ATS or ATS Abb-mx250 from the
drop-down list box.
– If the ATS model is OTM_C_D or ATS022,
select ATS. After adding a device, choose
Monitoring > Power Distribution > ATS
> Running Parameters and manually
modify the Detailed model based on the
actual model information.
– If the ATS model is MX250, select ATS
Abb-mx250.
Select System-Device name from the drop-
down list box.
Select COM2 from the drop-down list box.
In this example, Communications Port is
set to COM2. During actual configuration,
set the communications port based on the
actual situation.
In this example, Device Address is set to 1.
During configuration, set the actual device
address.
7 FAQ
111