Huawei FusionPower6000 Maintenance Manual page 104

FusionPower6000
Maintenance Guide
Step Operation
Setting
WAN_1
networking
parameters
Setting
NetEco
communica
tions
parameters
Add Devices Automatical
ly
discovering
devices
Adding a
transformer
temperatur
e controller
Issue 02 (2022-07-18)
Parameter
Local date
Local time
IP
Subnet mask
Default
gateway
Server IP
Port number
-
Device
Attribute
Device Type
Copyright © Huawei Digital Power Technologies Co., Ltd.
Setting
Set this parameter based on site
requirements.
Set this parameter based on site
requirements.
Set this parameter based on the site
plan.
Set this parameter based on the site
plan.
Set this parameter based on the site
plan.
Set this parameter based on the site
plan.
Set this parameter based on the site
plan.
The following devices can be
automatically discovered: smart ETH
gateway, WiFi module, cable inlet
and bus tie cabinet (separate or
combined), UPS, maintenance bypass
cabinet, and feeder cabinet.
Select Transformer from the drop-
down list box.
Select Transformer_LD-B10 or
Transformer-ABB-SCB11-2000 from
the drop-down list box.
● If the transformer is from
Huapeng, Siemens, Aux, or Taikai,
select Transformer_LD-B10.
● If the transformer is from ABB,
select Transformer-ABB-
SCB11-2000.
7 FAQ
Description
Click Obtain
Local Time
to
synchronize
the date and
time of the
ECC800-Pro
with the
date and
time on the
PC.
-
After the
setting is
complete,
click Test
Connect to
check
whether the
link is
successfully
set up.
-
Skip this
step if the
conditions
for powering
on the
transformer
temperature
controller
are not met.
After the
system is
powered on,
add devices
97