Powering On Fusionpower6000 3.0; Powering On The System; Commissioning A Ups; Power-On - Huawei FusionPower6000 Maintenance Manual

FusionPower6000
Maintenance Guide
●
Step 4 Start the inverter.
----End

7.6 Powering On FusionPower6000 3.0

7.6.1 Powering On the System

Step 1 Turn on the transformer input switch of the medium-voltage PDU.
Step 2 Check the transformer indicators to ensure that the equipment is running properly.
Step 3 (Optional) Perform impact tests on the cable inlet switch and bus tie switch
before operating the switches for the first time.
1.
2.
3.
Step 4 Turn on the cable inlet switch and check the indicator to ensure that the cable
inlet switch is turned on properly.
Step 5 (2N scenario) Press the RESET button on the ATS panel to switch the ATS control
mode to automatic. The Auto indicator is on. Then, set the switch to the
automatic position.
Step 6 Turn on the input switch of the compensation cabinet.
Step 7 Power on and start all UPSs. For details, see
7.6.3 Commissioning UPSs in a Parallel
Step 8 Turn on the feeder switches one by one and ensure that the voltage of the load
power input meets the requirements.
----End

7.6.2 Commissioning a UPS

7.6.2.1 Power-On

Step 1 Turn on the UPS bypass input switch, mains input switch, and output switch.
1.
2.
Issue 02 (2022-07-18)
Choose System Info > Alarms > Active Alarms to check that the EPO alarm
has been cleared.
On the WebUI
Choose Home > Active Alarm to check that the EPO alarm has been cleared.
Set the ACB to the TEST position and perform switch-on and switch-off
impact tests.
Set the ACB to the CONNECT position and perform switch-on and switch-off
impact tests.
After the testing is complete, ensure that the ACB is turned off.
Take the switch handle from the tray of the front door. Insert the switch
handle in place, and then rotate the switch handle.
Pull out the switch handle and place it back on the tray of the front door.
Ensure that the triangle arrow on the flange points to ON.
Copyright © Huawei Digital Power Technologies Co., Ltd.
7.6.2 Commissioning a UPS
System.
7 FAQ
and
71