Table of Contents
Advertisement
NAP- 200-009
Sheet 2/3
System Initialization and System
Data Entry
2. System Data Entry
• There are two methods for data entry, both of which employ a CAT or a MAT.
2.1 CAT (Customer Administration Terminal)
term
Any D
can be assigned as a CAT terminal through programming. The D
telephone when it is not in CAT mode. If the system is initialized by "C" (Resident System Program), every D
will be able to go into CAT mode. If the system is initialized by "B" (All Clear), only LEN0000 is assigned as a
CAT port (the LDC card must be installed in slot LT00).
term
To assign a D
as a CAT, follow the procedures shown below.
To set CAT mode:
1.
Press
TRF
2.
Press
CNF
- CNF lamp flashes
3.
Press
*
- CNF lamp is off
4.
Press
TRF
5.
Press
CNF
- CNF lamp flashes
6.
Press
#
- CNF, SPKR, ANS lamps are lit
- "CAT MODE" is displayed on LCD
7.
Press
ST
- "COMMAND = -" is displayed on LCD
Note: Steps 1 to 6 need to be completed within four (4) seconds.
AD-25182501
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
term
can still be used as a regular
CHAPTER 3
Revision 1.0.1
term
Page 109
Advertisement
Table of Contents
