1.4 Procedure for Unplugging/Plugging Circuit Cards
When removing a circuit card from the PIM, or when mounting a circuit card in the PIM, follow the procedure
given in Table 3-1 below.
Table 3-1 Procedure for Unplugging/Plugging Circuit Cards
CIRCUIT CARD
• PN-CP00 (MP)
• PZ-PW86/PW86(A)
(PWR)
• PN-BS00 (BS00)
• PN-BS01 (BS01)
• PN-CP01 (FP)
• PN-AP00 (AP00)
• PN-ME00 (EXTMEM)
• PN-BRTA (BRT)
• PN-CS00 (ATI)
• PN-30DTC (DTI)
• PN-SC00 (CCH)
• PN-SC01 (DCH)
1.5 Connecting Consoles' Cables
If possible, the ATI card (PN-CS00) should be unplugged when connecting/disconnecting the SN694 ATTCON
to/from the system. This is because there is some possibility that the console may be damaged.
Ensure that the Make Busy switch of the ATI card is on (Up) during removal/insertion.
PROCEDURE
PLUG IN
Power off
↓
Plug in
↓
Power on
Power off or
Power off or
MB switch on
MB switch on
↓
Plug in
↓
Power on or
MB switch off
AD-25182501
UNPLUG
Power off
These circuit cards must be plugged in
↓
or unplugged only with power off, to
Unplug
prevent damage to the card or other
↓
system circuitry.
Power on
These circuit cards must be plugged in
or
unplugged
↓
condition (or power off) to prevent
Unplug
damage to the card or other system
↓
circuitry.
Power on
CONDITION
under
Make
Busy
CHAPTER 3
Page 13
Revision 1.0.1