Table of Contents
Advertisement
NAP- 200-005
Sheet 2/4
Connection of Battery
(3)
Plug the battery-cable connector into the BATT1 connector on the PZ-PW86 as shown in Figure 005-2.
(4)
Secure the batteries and battery-cable using tie-wraps as shown in Figure 005-2.
(5)
When the system is a multiple-PIM configuration, connect the PZ-PW86 Cards to each other using PWR
CA-A cables, as shown in and Figures 005-4 or 005-5.
CHAPTER 3
Page 58
Revision 1.0.1
TIE WRAP
Figure 005-2: Internal Battery Connection
550mm
Figure 005-3 PWR CA-A
AD-25182501
+
FRONT
PWR CA-A
PLUG IN TO BATT 1
CONNECTOR ON PZ-PW86
Advertisement
Table of Contents
