Table of Contents
Advertisement
FusionCol8000-E400 Modular Indirect Evaporative
Cooling System
User Manual
Step 5 Perform a leakage test with nitrogen.
Step 6 After checking that there is no leakage, vacuumize the system and charge
refrigerant.
Step 7 Power on the unit and tap Start on the home screen. Ensure that the unit is
running normally without any alarms.
----End
9.6.2 Replacing a Compressor
Prerequisites
●
●
●
●
Context
● Reclaim or dispose of the refrigerant in accordance with local laws and
regulations. During the reclaim process, the R410A refrigerant composition may
change. Therefore, you are not advised to refill the reclaimed R410A refrigerant
to the cooling system.
● When replacing a compressor, avoid skin contact with the refrigerant or
lubricant to prevent frostbite or burns.
● Do not tilt the compressor during replacement to prevent lubricant leakage.
● Install a new compressor immediately after you remove the rubber plugs of
suction and discharge vents to prevent the moisture intake.
Issue 04 (2022-06-30)
Figure 9-10 Installing the filter dryer
A compressor needs to be replaced.
A spare compressor of the same model is available and functional.
To replace a compressor, you also need to replace the filter dryer.
Recommended tools and materials: welding torch, new compressor and filter
dryer, refrigerant reclaiming device, R410A refrigerant, refrigerant charging
device
NO TICE
Copyright © Huawei Technologies Co., Ltd.
9 Parts Replacement
132
Advertisement
Table of Contents
