Mitsubishi Electric MELSEC iQ-R Series User Manual page 18

Term
Remote station
Reserved address
Reserved station
Return
Routing
Safety communications
Safety connection
Safety data
SLMP
Standard communications
Standard station
Transient transmission
Transient transmission group No.
TSN hub
Unicast mode
*1 The term has been changed for standardization among manuals and software applications related to CC-Link IE TSN. However, the
term used in some CC-Link IE TSN related software windows may remain unchanged and may be different from the term used in this
manual.
In case of inconsistency, refer to the following.
Term used in software window
Authentication Class
16
Description
A station that exchanges I/O signals (bit data) and I/O data (word data) with another station by cyclic transmission. This
station can perform transient transmission.
An IP address reserved for special purposes, defined by RFC 6890. This IP address cannot be used when the
programmable controller is connected via the global IP network.
A station which is not actually connected. It is included as a station in the network when its all number is counted.
A process of restarting data link when a faulty station recovers from an error
A process of selecting paths for communication with other networks. There are two types of routing: dynamic routing that
auto-selects the communication routes, and static routing where communication routes are arbitrarily set.
A function to exchange safety data between safety stations on the same network
A connection established for safety communication
Data exchanged through safety communication
A SeamLess Message Protocol.
This protocol is used to access an SLMP-compatible device or a programmable controller connected to an SLMP-
compatible device from an external device.
Communications other than safety communications, such as cyclic transmission and transient transmission of CC-Link
IE TSN
A slave station other than the motion control (synchronization) station
A function of data communication unperiodically among nodes (station) on network.
A function used to send message to the target station when requested by a link dedicated instruction or the engineering
tool
Communication is available with station on another network via relay station, or gateway.
No. that is assigned for transient transmission to any given stations. By specifying a group of stations as transient
transmission target, data can be sent to the stations of the same group No.
A CC-Link IE TSN Class B switching hub authorized by CC-Link Partner Association
A communication mode used to send cyclic data to one station
Term after change
CC-Link IE TSN Class