Mitsubishi Electric MELSEC iQ-R Series User Manual page 51

Output data hold/clear operation during CPU STOP
The following figure shows the devices where the setting of "Output Hold/Clear Setting during CPU STOP" is enabled when
the CPU module changes from RUN to STOP.
Even if the Motion module is changed from RUN to STOP, it is not affected by this setting, and the output data
does not change even if the Motion module is stopped.
The program is changed from STOP to ON when the PLC ready [Y0] is turned on.
■ Unicast mode
No.0
RX
No.1
No.2
No.3
RY
No.1
No.2
No.3
RWr
No.1
No.2
No.3
RWw
No.1
No.2
No.3
LB
No.0
No.2
No.3
LW
No.0
No.2
No.3
: When the link refresh source is set to other than Y, data is held or cleared according to the parameter setting. When the link refresh source is set to Y, data
is cleared regardless of the parameter setting.
: Data is held regardless of the parameter setting.
No.1
RX
No.1
RY
No.1
RWr
No.1
RWw
No.1
No.2 No.3
RX
No.2
No.3
RY
No.2
No.3
RWr RWr
No.2
No.3
RWw RWw
No.2
No.3
LB
No.0 No.0
No.2
No.3
LW
No.0 No.0
No.2
No.3
1 FUNCTIONS
1.1 Cyclic Transmission
1
RX
RY
LB
LW
49