Table of Contents
Advertisement
Figure 164. Unplugging the power cord from an AC power supply/cooling module
3. On a DC power/cooling module, pinch the spring releases on each side of the power cord plug and pull the plug out of the
connector.
Figure 165. Unplugging the power cord from a DC power supply/cooling module
4. Remove the power/cooling module as follows:
a. Press the orange handle button to release the module.
b. Pull the latch outward, and remove the power/cooling module from its slot.
CAUTION:
To protect a running system from overheating, the enclosure powers down unless you replace
the power cooling module within two minutes.
136
SAS expansion enclosure service procedures
Spring
Release
CL5060
Advertisement
Table of Contents
