Table of Contents
Advertisement
Figure 80. Seating the 2-port 100GbE card
3. Gently push down on the 2-port 100GbE card.
4. Push up on the blue tabs until they lock into place.
Figure 81. Locking the 2-port 100GbE card into position
5. Install the air dam and tighten the captive screws.
6. Install the SFPs into the embedded module.
Install an embedded module
Steps
1. Align the embedded module with the empty slot and carefully push it into the slot.
As the embedded module is installed, the release lever rotates inward.
Base enclosure service procedures
79
Advertisement
Table of Contents
