Power Down The Node; Remove A Faulted Embedded Module - Dell PowerStore 1000 Installation And Service Manual

Table 4. Embedded module LEDs (continued)
LED
Node power
Node fault
Port link
Ethernet port activity
Ethernet port link
2-port 100GbE card port link
Embedded module fault
2-port 100GbE card port activity

Power down the node

Power down the node as described in

Remove a faulted embedded module

Steps
1. Label and disconnect all cables that are attached to the embedded module.
CAUTION: Do not pull the node from the base enclosure. Pulling the node from the base enclosure disrupts
the system cache.
2. Push the orange tab on the embedded module to release the lever.
Location
Power control procedures.
State Description
Off Safe to remove the node when the node
has been properly prepared.
Green Node is on (main power).
Green blinking Node is initializing a serial over LAN
session.
Off Node is off.
Amber Fault has occurred.
Blue Node in Degraded Mode.
Amber or blue System is booting.
blinking
Blue and amber System uninitialized. A management IP
alternating (green address has not been assigned.
for 3 seconds)
Blue and amber Node in Service Mode.
alternating at one
second intervals
Green Link up with high speed.
Amber Link up with degraded speed.
Off Link down.
Amber blinking Port activity.
Off No port activity.
Green Link established.
Off No link established.
Green Link established.
Off No link established.
Amber Embedded module has faulted.
Off No fault has occurred, normal operation.
Green blinking Port activity.
Off No port activity.
Base enclosure service procedures 63