Table of Contents
Advertisement
Figure 47. Pushing the latch cover up
3. Push down the orange button to release the latch.
4. Remove the drive from the slot.
Figure 48. Removing a 2.5" drive
5. Place the drive on a static-free surface.
Install a 2.5" drive
About this task
NOTE:
If you are installing multiple drives in a system that is powered up, wait at least 10 seconds before sliding the next
drive into position.
NOTE:
NVMe SSD and NVMe SCM drives must be installed from left-to-right starting with the first available slot.
NOTE:
NVMe NVRAM drives are used for system caching and can only be installed in the last four slots (21 through 24) of
the base enclosure. In configurations that only use two NVMe NVRAM drives, slots 21 and 22 must remain empty.
Steps
1. Align the drive with the guides in the slot.
2. With the latch fully opened, gently push the drive into the slot.
The latch begins to rotate downward when it meets the enclosure.
54
Base enclosure service procedures
Advertisement
Table of Contents
