2. Push down the two blue tabs on the back of the 2-port 100GbE card to release the 2-port 100GbE card.
Figure 78. Opening the retaining tabs
3. Lift the 2-port 100GbE card off the pegs, and pull the 2-port 100GbE card away from the embedded module.
NOTE:
If you are having difficulty removing the 2-port 100GbE card, loosen the captive screws that secure the air dam
to the front of the embedded module .
Figure 79. Removing the 2-port 100GbE card
Install a 2-port 100GbE card
Steps
1. Align the 2-port 100GbE card in the embedded module so that the ports on the front line up with the slots on the front of
the embedded module.
2. Align the white pegs beneath the holes on the 2-port 100GbE card.
CAUTION:
Do not force the 2-port 100GbE card into place. If the 2-port 100GbE card does not smoothly seat,
realign the pegs and try again.
78
Base enclosure service procedures