Table 5. Embedded module LEDs (continued)
LED
Power down the node
Power down the node as described in
Remove an embedded module
Steps
1. Label and disconnect all cables that are attached to the embedded module.
CAUTION:
Do not pull the node from the base enclosure. Pulling the node from the base enclosure disrupts
the system cache.
2. Push the orange tab on the embedded module to release the lever.
Figure 67. Releasing the lever on the embedded module
3. Pull the release lever away from the system. The embedded module releases from the system as you pull the lever.
70
Base enclosure service procedures
Location
Power control
procedures.
State
Description
Off
No port activity.