Table of Contents
Advertisement
2. Push the power supply into the node until it clicks into place.
Figure 180. Installing a power supply
3. Connect the power cable to the power supply and secure the cord with the retention bail at the connector.
Figure 181. Inserting the power cable
Verify the operation of a replacement power supply
Steps
1. From PowerStore Manager, select Hardware.
2. Select the appliance where you replaced the power supply.
3. On the Components card, under Rear View, expand ExpansionEnclosure.
4. Expand the node that includes the power supply, and then select PSU0.
The status of the replacement power supply should read Healthy. If the status is still Faulted, wait a few minutes and
refresh PowerStore Manager. If the status does not change, ensure that the power supply is correctly seated, or contact
your service provider.
Return a faulted part
About this task
For US customers, return defective material within five business days. For International customers, return defective material
within 10 business days. The materials required to return your defective part are supplied with the good part shipment.
NVMe expansion enclosure service procedures
149
Advertisement
Table of Contents
