Hitachi Relion 670 Series Applications Manual page 179

1MRK506375-UEN Rev. N
No. StartMode
FunctionMode = Current or CB Pos
19 LatchedStart
20 LatchedStart
21 LatchedStart
22 FollowStart
23 FollowStart
24 FollowStart
25 FollowStart&M
ode
Table continues on next page
Railway application RER670
Application manual
RetripMode t1 and t2 initiated
with
Off external START
UseFunctionMo external START
de
Always external START
Off external START
UseFunctionMo external START
de
Always external START
Off external START and
current above set
level
© 2017 - 2023 Hitachi Energy. All rights reserved
When t1 has When t2 or t2MPh
elapsed, TRRET will has elapsed, TRBU
will be given if
never be given current is above set
level *) and higher
than I>BlkCBPos or
CBCLDLx input has
logical value one
when current is
smaller than
I>BlkCBPos
be given if current is current is above set
above set level of level *) and higher
IPh> and higher than than I>BlkCBPos or
I>BlkCBPos or CBCLDLx input has
CBCLDLx input has logical value one
logical value one when current is
when current is smaller than
smaller than I>BlkCBPos
I>BlkCBPos
always be given current is above set
level *) and higher
than I>BlkCBPos or
CBCLDLx input has
logical value one
when current is
smaller than
I>BlkCBPos
never be given current is above set
level *) and higher
than I>BlkCBPos or
CBCLDLx input has
logical value one
when current is
smaller than
I>BlkCBPos
be given if current is current is above set
above set level of level *) and higher
IPh> and higher than than I>BlkCBPos or
I>BlkCBPos or CBCLDLx input has
CBCLDLx input has logical value one
logical value one when current is
when current is smaller than
smaller than I>BlkCBPos
I>BlkCBPos
be given if external current is above set
START is present level *) and higher
than I>BlkCBPos or
CBCLDLx input has
logical value one
when current is
smaller than
I>BlkCBPos
never be given current is above set
level *) and higher
than I>BlkCBPos or
CBCLDLx input has
logical value one
when current is
smaller than
I>BlkCBPos
Section 8
Current protection
t1 and t2 and t2MPh
will be stopped
(reset) if
t1 and (t2 or t2MPh)
and 150ms expires
and current is below
set level *) or
CBCLDLx input has
logical value zero
t1 and (t2 or t2MPh)
and 150ms expires
and current is below
set level *) or
CBCLDLx input has
logical value zero
t1 and (t2 or t2MPh)
and 150ms expires
and current is below
set level *) or
CBCLDLx input has
logical value zero
external START
disappears
external START
disappears
external START
disappears
current is below set
level *) or external
START disappears
173