1MRK506375-UEN Rev. N
Alarm indicators
The 15 programmable three-color LEDs are used for alarm indication. An individual alarm/status
signal, connected to any of the LED function blocks, can be assigned to one of the three LED colors
when configuring the IED.
Table 13:
LED state
OFF
ON
Flashing/
blinking
5.4.2
Parameter management
The LHMI is used to access the relay parameters. Three types of parameters can be read and
written.
•
Numerical values
•
String values
•
Enumerated values
Numerical values are presented either in integer or in decimal format with minimum and maximum
values. Character strings can be edited character by character. Enumerated values have a
predefined set of selectable values.
5.4.3
Front communication
The RJ-45 port in the LHMI enables front communication.
•
The green uplink LED on the left is lit when the cable is successfully connected to the port.
•
The yellow LED is not used; it is always off.
Railway application RER670
Application manual
Alarm indications
Description
Normal operation. All activation signals are OFF.
•
Follow-S sequence: The activation signal is ON.
•
LatchedColl-S sequence: The activation signal is ON, or it is off but the indication has not been
acknowledged.
•
LatchedAck-F-S sequence: The indication has been acknowledged, but the activation signal is
still ON.
•
LatchedAck-S-F sequence: The activation signal is ON, or it is off but the indication has not
been acknowledged.
•
LatchedReset-S sequence: The activation signal is ON, or it is off but the indication has not
been acknowledged.
•
Follow-F sequence: The activation signal is ON.
•
LatchedAck-F-S sequence: The activation signal is ON, or it is off but the indication has not
been acknowledged.
•
LatchedAck-S-F sequence: The indication has been acknowledged, but the activation signal is
still ON.
© 2017 - 2023 Hitachi Energy. All rights reserved
Section 5
Local HMI
GUID-5EE466E3-932B-4311-9FE1-76ECD8D6E245 v9
GUID-FD72A445-C8C1-4BFE-90E3-0AC78AE17C45 v14
69