Table of Contents
Advertisement
[LCD FOCUS ASSIST]
[EXPAND MODE]
Sets the enlargement display function mode.
[10SEC]
[HOLD]
[UNTIL REC]
(Factory setting: [10SEC])
[EXPAND VALUE]
Adjusts the enlargement factor of the enlarged display function.
The items that can be set are as follows.
f [x2], [x3], [x4]
(Factory setting: [x2])
[PEAK./SQUARES MODE]
Enables/disables the peaking function and focus square display (focus assist function).
[PEAKING]
[SQUARES]
[PEAK./SQUARES]
(Factory setting: [SQUARES])
[PEAKING LEVEL]
Sets the intensity of the peaking display.
The items that can be set are as follows.
f [LOW], [MID], [HIGH]
(Factory setting: [MID])
[PEAKING COLOR]
Sets the color of the peaking display.
The items that can be set are as follows.
f [RED], [GREEN], [WHITE]
(Factory setting: [RED])
[BLACK & WHITE]
Enables/disables the monochrome display.
[ON]
[OFF]
[DURING PEAK./SQUARES]
(Factory setting: [OFF])
[OPEN IRIS MODE]
Sets the time for the open iris focus assist function is to operate. The open iris focus assist function is forced to cancel when the recording is started.
The items that can be set are as follows.
f [10SEC], [30SEC]
(Factory setting: [10SEC])
[LCD EI ASSIST]
[ZEBRA]
Sets if the zebra signal is superimposed or not to the output from the <LCD> terminal.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[ZEBRA1 DETECT]
Sets the detection level of zebra pattern 1.
The items that can be set are as follows.
f [0%]...[109%]
(Factory setting: [80%])
Chapter 4 Operation — Menu setting contents
Disables the enlarged display function after ten seconds have elapsed.
The enlarged display function is enabled until the USER button assigned with [EXPAND] is pressed again.
Enables the enlarged display function until performing recording operation.
Enables the peaking display.
Enables the focus square display.
Enables peaking display and the focus square display. It will switch in the order of peaking display, focus square display, and
no display every time the USER button with [PEAK./SQUARES F.A.] assigned is pressed.
Enables the monochrome display.
Disables the monochrome display.
The monochrome display is enabled while the peaking display and the focus square display is enabled.
– 100 –
Advertisement
Table of Contents
