Panasonic AU-EVA1 Operating Instructions Manual page 91

The items that can be set are as follows.
f [4dB], [0dB]
(Factory setting: [4dB])
[INPUT2 LINE LEVEL]
Sets the audio input level of the audio device connected to the <AUDIO INPUT 2> terminal. Enabled when the audio device is connected and [INPUT2
LINE/MIC SEL] of [AUDIO INPUT] is set to [LINE].
The items that can be set are as follows.
f [4dB], [0dB]
(Factory setting: [4dB])
[AUDIO OUTPUT]
[MONITOR OUT]
Sets the audio channel and the format to be output from the headphone terminal.
[CH1]
[CH2]
[STEREO]
[MIX]
(Factory setting: [STEREO])
[MONITOR DELAY]
Sets if the audio from the headphone terminal is to be delayed to match the video on the LCD monitor.
[LIVE]
[RECORDING]
(Factory setting: [LIVE])
[MONITOR VOL]
Adjusts the level of audio output from the headphone terminal.
The items that can be set are as follows.
f [0]...[100]
(Factory setting: [70])
[REC BEEP SOUND]
[MODE]
Sets if the beep sound is generated when starting or stopping the recording.
[OFF]
[START]
[STOP]
[START&STOP]
(Factory setting: [OFF])
[VOLUME]
Sets the volume of the beep sound when starting or stopping the recording.
The items that can be set are as follows.
f [HIGH], [MED], [LOW]
(Factory setting: [MED])
[ALARM]
[BATTERY END]
Sets if the alarm is to be sounded when the remaining battery level is exhausted.
The items that can be set are as follows.
f [HIGH], [MED], [LOW], [OFF]
(Factory setting: [MED])
[MEDIA END]
Sets if the alarm is sounded when the remaining recordable capacity of the SD card is exhausted.
The items that can be set are as follows.
f [HIGH], [MED], [LOW], [OFF]
(Factory setting: [MED])
@ NOTE
t Volume of the alarm during system error is fixed to [MED].
Chapter 4 Operation — Menu setting contents
Outputs the signal for audio channel 1 as monaural.
Outputs the signal for audio channel 2 as monaural.
Outputs the signals of the audio channel 1 and the audio channel 2 as stereo.
Mixes the signals of the audio channel 1 and the audio channel 2 and outputs as monaural.
Outputs without delay.
Matches to the video on the LCD monitor.
The beep sound is not generated.
The beep sound is generated only when the recording is started.
The beep sound is generated only when the recording is stopped.
The beep sound is generated when the recording is started and stopped.
– 91 –