Table of Contents
Advertisement
[CROP&MIX 2K]
(Factory setting: [OFF])
@
NOTE
t When the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [FREQUENCY] is set to [50.00i]/[59.94i], this is fixed to [OFF].
t When the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [FREQUENCY] is set to [50.00p]/[59.94p], [S35 5.7K] cannot be selected.
t Following conditions apply when set to anything other than [OFF].
‑ Recording to an SD card with the camera is not possible.
‑ The [SYSTEM SETTINGS] menu → [COLOR SETTINGS] → [MAIN] will be fixed to [V-Log].
‑ The [CAMERA SETTINGS] menu → [EI] → [MODE] will be fixed to [ISO].
‑ The thumbnail screen is not displayed.
‑ [E.I.S.], [D.ZOOM], [PRE REC], [REC CHECK], [DEL LAST CLIP], [SLOT SEL], [SDI COLOR], and [COLOR BARS] assigned to the USER button
will not operate.
‑ The [OUTPUT SETTINGS] menu → [SDI OUT] → [SDI REC REMOTE] and the [OUTPUT SETTINGS] menu → [HDMI OUT] → [HDMI REC
REMOTE] will not operate.
‑ The time code information is not output in the image output from the <HDMI> terminal.
[SENSOR MODE]
Sets the drive mode of the image sensor.
[S35 5.7K]
[S35 MIX 2.8K]
[4/3 CROP&MIX 2.2K]
(Factory setting: [S35 5.7K])
@
NOTE
t When the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [SENSOR MODE] → [4/3 CROP&MIX 2.2K] is set
‑ The sensitivity will be lower than when [S35 5.7K] or [S35 MIX 2.8K] is set.
‑ The items that can be set in the [CAMERA SETTINGS] menu → [EI] → [NATIVE ISO] will be [400 ISO] or [1250 ISO].
t When the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [SDI RAW] is set to anything other than [OFF], this cannot be set.
[MAIN PIXEL]
Sets the main recorder's number of recording pixels.
The items that can be set are as follows.
f [4096x2160], [3840x2160], [2048x1080], [1920x1080], [1280x720]
(Factory setting: [4096x2160])
@
NOTE
t When the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [SDI RAW] is set to anything other than [OFF], this cannot be set.
[MAIN CODEC]
Sets the recording codec of the main recorder.
f MOV file
[420LongGOP 150M]
[420LongGOP 100M]
[420LongGOP 50M]
[422LongGOP 150M]
[422LongGOP 100M]
[422LongGOP 50M]
[422ALL-I 400M]
[422ALL-I 200M]
[422ALL-I 100M]
f AVCHD file
[AVCHD PS]
[AVCHD PH]
[AVCHD HA]
[AVCHD PM]
(Factory setting: [422LongGOP 150M])
NOTE
@
t When the [SYSTEM SETTINGS] menu → [SYSTEM MODE] → [SDI RAW] is set to anything other than [OFF], this cannot be set.
Chapter 4 Operation — Menu setting contents
Performs the RAW output of the 2048×1080 pixels by cutting out the center section of the image sensor and performing the
pixel mixing read.
This allows high-speed shooting up to 240p. Angle of view will change.
Uses the entire pixels of the image sensor.
Performs pixel mixing read of 2.8K from the entire image sensor.
This allows high-speed shooting up to 120p.
Performs the pixel mixing read of 2.2K by cropping the Four Thirds image circle from the center of the image sensor.
This allows high-speed shooting up to 240p. Angle of view will change.
4:2:0 (8 bits) LongGOP 150 Mbps
4:2:0 (8 bits) LongGOP 100 Mbps
4:2:0 (8 bits) LongGOP 50 Mbps
4:2:2 (10 bits) LongGOP 150 Mbps
4:2:2 (10 bits) LongGOP 100 Mbps
4:2:2 (10 bits) LongGOP 50 Mbps
4:2:2 (10 bits) ALL-Intra 400 Mbps
4:2:2 (10 bits) ALL-Intra 200 Mbps
4:2:2 (10 bits) ALL-Intra 100 Mbps
4:2:0 (8 bits) LongGOP 25 Mbps
4:2:0 (8 bits) LongGOP 21 Mbps
4:2:0 (8 bits) LongGOP 17 Mbps
4:2:0 (8 bits) LongGOP 8 Mbps
– 74 –
Advertisement
Table of Contents
