Table of Contents
Advertisement
[B.GAMMA RANGE]
Sets the maximum level to perform compression/expansion of dark area.
The items that can be set are as follows.
[1]
[2]
[3]
[KNEE]
[KNEE SW]
Enables/disables operation of the knee.
The items that can be set are as follows.
f [ON], [OFF]
[KNEE MODE]
Sets the knee operation mode.
[D RANGE]
[PRESS]
[KNEE POINT]
Sets the position of the knee point.
The items that can be set are as follows.
f [55%] ... [100%] (1% steps)
[KNEE SLOPE]
Sets the knee inclination.
The items that can be set are as follows.
f [0]...[100]
[HLG KNEE]
[KNEE SW]
Enables/disables the operation of knee for HLG.
The items that can be set are as follows.
f [ON], [OFF]
[KNEE POINT]
Sets the position of the knee point for HLG.
The items that can be set are as follows.
f [55%]...[109%] (1% steps)
[KNEE SLOPE]
Sets the inclination of knee for HLG.
The items that can be set are as follows.
f [0]...[100]
[WHITE CLIP]
[SW]
Switches the enable/disable of the white clip function.
The items that can be set are as follows.
f [ON], [OFF]
[LEVEL]
Sets the level of the white clip.
The items that can be set are as follows.
f [90%]...[109%]
[DETAIL]
[SW]
Switches the enable/disable of the detail function.
The items that can be set are as follows.
f [ON], [OFF]
Chapter 4 Operation — Menu setting contents
Around 20%
Around 30%
Around 40%
The dynamic range that can be represented is determined by the value of [KNEE SLOPE] in [KNEE].
The value of dynamic range that can be represented does not change even when the value of [KNEE POINT] in [KNEE] is
changed.
The compression rate of the signal is determined by the value of [KNEE SLOPE] in [KNEE].
The value of dynamic range that can be represented will change when the value of [KNEE POINT] in [KNEE] is changed.
– 85 –
Advertisement
Table of Contents
