[CH2 MIC LOWCUT]
Enables/disables the lowcut filter for audio channel 2.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[CH1 LIMITER]
Enables/disables the limiter when the method to adjust the audio input level for audio channel 1 is manual.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[CH2 LIMITER]
Enables/disables the limiter when the method to adjust the audio input level for audio channel 2 is manual.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[HEAD ROOM]
Sets the headroom (standard level).
The items that can be set are as follows.
f [18dB], [20dB]
(Factory setting: [20dB] (when [AREA SETTINGS] is set to [AREA 1]/[AREA 2]), [18dB] (when [AREA SETTINGS] is set to [AREA 3]))
[AUDIO INPUT]
[INPUT1 LINE/MIC SEL]
Sets the audio input signal from the device connected to the <AUDIO INPUT 1> terminal.
[LINE]
[MIC]
(Factory setting: [LINE])
[INPUT2 LINE/MIC SEL]
Sets the audio input signal from the device connected to the <AUDIO INPUT 2> terminal.
[LINE]
[MIC]
(Factory setting: [LINE])
[INPUT1 MIC POWER]
Enables/disables the phantom power supply for the external microphone connected to the <AUDIO INPUT 1> terminal.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[INPUT2 MIC POWER]
Enables/disables the phantom power supply for the external microphone connected to the <AUDIO INPUT 2> terminal.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[INPUT1 MIC LEVEL]
Sets the input level of the external microphone connected to the <AUDIO INPUT 1> terminal. Enabled when the external microphone is connected and
[INPUT1 LINE/MIC SEL] of [AUDIO INPUT] is set to [MIC].
The items that can be set are as follows.
f [-40dB], [-50dB], [-60dB]
(Factory setting: [-60dB])
[INPUT2 MIC LEVEL]
Sets the input level of the external microphone connected to the <AUDIO INPUT 2> terminal. Enabled when the external microphone is connected and
[INPUT2 LINE/MIC SEL] of [AUDIO INPUT] is set to [MIC].
The items that can be set are as follows.
f [-40dB], [-50dB], [-60dB]
(Factory setting: [-60dB])
[INPUT1 LINE LEVEL]
Sets the audio input level of the audio device connected to the <AUDIO INPUT 1> terminal. Enabled when the audio device is connected and [INPUT1
LINE/MIC SEL] of [AUDIO INPUT] is set to [LINE].
Chapter 4 Operation — Menu setting contents
Sets this when an audio device is connected.
Sets this when an external microphone is connected.
Sets this when an audio device is connected.
Sets this when an external microphone is connected.
– 90 –