Ir Shooting - Panasonic AU-EVA1 Operating Instructions Manual

f To clear the setting, set the [REC SETTINGS] menu → [REC FUNCTION] → [REC MODE] to [NORMAL].
f The setting is not cleared even when the power is turned off.
@ NOTE
t Audio is not recorded.
t Recorded data (data recorded until recording was stopped) is included in one clip.
t The [REC SETTINGS] menu → [TC] → [FREE/REC RUN] is fixed to [REC RUN].
t The [REC SETTINGS] menu → [TC] → [DF/NDF] is fixed to [NDF].
t [SDI REC REMOTE] and [HDMI REC REMOTE] will not operate.
t If the length of the clip is less than three seconds when the recording is stopped, the image of the final frame will be recorded to make the length of the
clip to three seconds.
t The recording is stopped once when the length of the clip exceeds ten hours in the interval recording. The recording is automatically resumed after
few seconds.
t For recording limitation of the interval recording, refer to "Recording function that cannot be used simultaneously".

IR shooting

A night time shooting using the IR light can be performed.
r Assigning [IR SHOOTING] to the USER button
1
Select the [SYSTEM SETTINGS] menu → [USER SWITCHES] → [USER1] to [USER9] → [IR SHOOTING].
Set so enable/disable of the IR shooting can be switched with an arbitrary USER button.
r Performing IR shooting
1
Press the USER button that [IR SHOOTING] is assigned.
The camera will enter the IR shooting mode.
2
Press the REC button.
IR shooting is started.
@ NOTE
t It can also be set with the [CAMERA SETTINGS] menu → [IR SHOOTING].
Chapter 5 Shooting — Special recording function
– 131 –