Fujitsu AIRSTAGE UTY-ASGX Manual page 124

T-7 During scanning, PC power was dropped by a power failure or erroneous operation
and operation became unstable.
Countermeasure
At a power failure, incomplete data remains and operation may be performed with
this incomplete data at the next starting. Repeat scanning. When the power was in-
terrupted during another operation, the operation may return to normal by the same
operation after resetting.
T-8 Air conditioner is not controlled in R.C. group units.
Cause
R.C group data cannot be acquired.
Countermeasure
Repeat scanning by detailed information scanning setting.
T-9 Pop-up window does not show up in the Service Tool screens. (Control screen, Com-
missioning tool, etc.)
Cause
Pop-up Blocker is enabled in the Internet Explorer.
Countermeasure
Open Internet Explorer
Pop-up Blocker]
If any of the search tool bar from various search engines (Yahoo, Google etc.)
is installed, disable the Pop-up Blocker.
(For detail, refer the help of each toolbar.)
T-10 Refrigerant circuit diagram is not displayed for outdoor/indoor unit in the Detail screen
(diagram).
(Message "Cannot display refrigerant circuit diagram" is displayed).
Cause
Model name was not acquired from indoor/outdoor unit (V-II/J-II/J-IIS/VR-II/V-III
series).
Countermeasure
Perform scan again (Refer section 3-2-( Scanning).
After scanning, check that the model name is displayed in the System List
screen.
122
[Tools] [Pop-up Blocker] and check [Turn Off
Copyright© 2009-2016 Fujitsu General Limited. All rights reserved.