Fujitsu AIRSTAGE UTY-ASGX Manual page 20

Perform System Initialization check
Can be used only when
Check when you want to acquire more detailed information by
scanning. (*2)
When checked, a confirmation screen is displayed. When the
clicked, all the units in the VRF System may be temporarily stopped.
When the
OK button
• When "Enable Scan" checked
When the
displayed on the scanning progress screen.
Before scanning starts, whether or not scanning
is to be performed is displayed on a confirmation
screen.
When re-scanning, dialog box will appear after
selecting the start of scan, confirming whether the
existing indoor/outdoor units data (operation data,
etc.) may be deleted.
Yes ... delete the data after scanning, No ... Keep
the data,
* When performing scanning selecting "No" and number of units before and after
scanning mismatches, following symptom may be encountered. Therefore, when
selecting "No", be sure to have the correct number of units before and after scan-
ning in mind.
• Transmission error may occur for the units that ceased to exist after scanning.
• Delay may occur for collecting data for each unit.
• When "Enable Scan" not checked
When the
scanning. But when CSV formatted Name master file (3-2-4) has been already read,
the corresponding Name of the unit will be updated.
Cancel button
When the
18
is checked.
button was clicked, the check mark is removed.
button is clicked, scanning starts and scanning progress is
button is clicked, the system list screen is displayed without
button is clicked, the online site selection screen is displayed.
Copyright© 2009-2016 Fujitsu General Limited. All rights reserved.
button is
OK button