Fujitsu AIRSTAGE UTY-ASGX Manual page 67

Graph area
„ „
Graphs are displayed by clicking each button of the control item from the indoor unit/outdoor
unit schematic area.
The graph item/unit name (if set) are displayed at the top left-hand corner of the
Name
graph area.
Upper and lower limit of Y axis of the graph may arbitrary be set (*1). Allowable
range for each graph types is as follows.
• Temp: -75~185 °C/-103~365 °F
YAxis
• Pressure: 0~5 Mpa/-145~730 psi
• EEV: 0~2000 Pulse
• CMP: 0~300 rps(Hz)
Print Displays the print confirmation window. (*2)
Enlarge Enlarges and displays a graph. (*2)
Line Displays the graph line selection screen. (*2)
Close Closes the graph.
The probe is moved to the left and right by dragging it with the mouse.
The unit status received at the past time at the probe position is reflected on the
Probe
schematic. When a past unit status is referenced, the "Auto refresh" check mark is
automatically removed. (*3)
*1 For details, refer to the next clause (Graph area details).
Note
*2 When displaying the files created by previous version of this product (Ver.
1.1:mdb files) in offline mode, indoor and outdoor unit data corresponding to
the time position of the probe may not synchronize. This is because in previ-
ous version, the data collecting method of the Service Tool was different from
the present version.
*3 After upper and lower limit is set, scale for the Y axis will evenly be appor-
tioned. Therefore, the scale may slightly be different from the actual value.
Copyright© 2009-2016 Fujitsu General Limited. All rights reserved.
Probe
6(