Fujitsu AIRSTAGE UTY-ASGX Manual page 81

5-7-2 Operating∙procedure
Selects the test items and the units to be tested from all the units stopped status.
Check the refrigerant circuit address to which the units which are to be test run
at "Ref." on the screen.
Since the refrigerant circuit address specified at the detail screen is displayed here,
when making changes, after re-specifying by (-( Detail screen and clicking the OK but-
ton, start the commissioning tool.
Select the test pattern according to the item to be test run.
For test run by cooling, select "Cooling Test" and for test run by heating, select "Heating
Test".
Select the unit which is to start test run. Select the unit by clicking the button of
the relevant unit No.
The selected unit is displayed by a red italic numeric.
For outdoor units, when any button is selected, all the indoor units also enter the se-
lected state. For indoor units, when any button is selected, all the units that belong to
the same R.C. group as the selected unit No. also enter the selected state.
When the
is started.
Copyright© 2009-2016 Fujitsu General Limited. All rights reserved.
button is clicked in the units selected state, test run
79