Fujitsu AIRSTAGE UTY-ASGX Manual page 26

Note • Units that cannot be acquired by address checker are not scanned.
• When the same address is displayed at outdoor units or indoor units, it indi-
cates that the address is duplicated. (Except RB unit and S/V series outdoor
unit/indoor unit) However, address duplication is not always acquired, de-
pending on network data collision, and other effects.
• When the RB unit is in the following states, the addresses are not displayed.
- When not connected to indoor unit
- When connected indoor unit power is off
Total unit list
Displays the number of outdoor units and indoor units and RB units and the total num-
ber of units (outdoor units + indoor units + RB units) displayed at
Multi type RB units are counted by duplicating the number of units connected to piping
individually. (Maximum ( units) Therefore, the number of displayed RB units may be
larger than the actual number of units.
Clear button
Clears the list of
When the list is cleared, the scanning by [Checked address] cannot be performed.
Start button
Address check Start/End button. When not performing an address check, this serves
as the Start button, and when performing an address check, this serves as the End
button.
Close button
Closes this window. When performing an address check, this button is disabled.
2(
. When performing an address check, this button is disabled.
Copyright© 2009-2016 Fujitsu General Limited. All rights reserved.
.