Exiting∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙46 - Fujitsu AIRSTAGE UTY-ASGX Manual

4-4 Exiting
Exits the Service Tool. When exited, the unit data acquired up to that point can be saved as
an Export file, as required. Care is required because all the data which is not saved when
exiting is deleted.
The saved Export file can be referenced later in the offline mode. (See par. 3-3-1 Import file
selection.)
Date setting field
Specify the date range of the data you want to save.
Ref. No. setting field
When you want to save the data of all the refrigerant circuit address, select "All".
When you want to save the data of a specific refrigerant circuit address, select "Ref".
Ref. No. setting field
This field can be used only when "Ref" was selected.
Select the refrigerant circuit address to be saved.
Save Export file & Exit button
Creates an Expert file and exits the Service Tool.
When the
save file dialog screen is displayed. Set the Export file save
location and save name.
When the
clicked, Export file creation under the conditions set on the
screen starts. After the end of creation, the program exits from the Service Tool.
Exit without saving Export file button
When the
Tool without creating an Export file. When exiting the Service Tool, all the unit data
other than the system list is deleted. Therefore, when data must be referenced later,
save the data by selecting "Save Export file & Exit".
(6
button is clicked, the
button of the save file dialog screen is
button is clicked, the program exits the Service
Copyright© 2009-2016 Fujitsu General Limited. All rights reserved.