4 INSTALLATION, WIRING AND MAINTENANCE OF THE PRODUCT
[Wiring example of shielded cable]
Connector
(A6CON1)
To QD75MH
The length between the connector and the shielded
cables should be the shortest possible.
The following shows a wiring example for noise reduction in the case where the
connector A6CON1 is used.
For forced stop
Shielded
input signal
cable
For manual paluse
generator signal
Use the shortest possible length to
ground the 2mm or more FG wire.
(The shield must be grounded on
the QD75MH side.)
4 - 13
MELSEC-Q
For limit signal
and etc.