HP 3336A Operating Manual page 103

Performance Tests
Cables:
(1) 50 ohm, | ft. -hp- 11170A
(1) 50 ohm, 2 ft. -hp- 11170B
(1) 50 ohm, 3 ft. -hp- 11170C
Adapters: 50 ohm
(1) Type N (m) to BNC (m) -hp- 1250-0082
(2) Type N (f) to BNC (m) -hp- 1250-0077
(1) Type N (m) to BNC (f) -hp- 1250-0780
(1) BNC (f) to Dual Banana -hp- 1251-2277
(1) BNC (m) to BNC (m) -hp- 1250-0216
Adapters: 75 ohm
(1) BNC (m) to BNC (m) -hp- 1250-1288
NOTE
Q Bit Corporation; P.O. Box 2208; Melbourne, Florida 32901.
Model 3336A/B/C
a. Connect the equipment electrically as shown in Figure 4-4 and physically as shown in
Figure 4-5.
NOTE
The quality of the test results depends upon the equipment ar-
rangement. It is important that the physical location of the in-
struments be as shown in Figure 4-5. Do not cross cables. Allow
the Q-Bit Amplifier 30 minutes to warm-up.
b. Set the 3336 (DUT) controls as follows:
Ampltiude..............0. cee eeee +7.00 dBm (75 ohm output)
FIEQUENCY «6.036 sot es eb wale eco ee eee heeoele GbE eae Suet 20 MHz
c. Set the Reference Synthesizer as follows:
Amplitude... 0.5.0.0. 5.00 c ee eeeee +7.00 dBm (50 ohm output)
Frequency. ¢ scion vied eee teach eee tA eet 20.008 MHz
d. Set the Wave Analyzer controls as follows:
SCale obs dn hha eee SSC Ree wld ree GA WO ST ews He" Volts
Resolution Bandwidth... ............. ccc eee eee eee eee 100 Hz
Sweep: Mod@i.csisswdied sc awtotw segeyeew esr Manual
Amplitude Reference Level............ 0... cess ee ee ees Normal
Input Sensitivity (initially)............ 6. cece eee ee eee 1V
Input, (3581C).2..scci eek ke ind ee ge ed os Unbalanced
AEC enti eit atanien ates OUT; Tune Frequency to 8 kHz
ARCS icc cng ttleiteechaskios > Push IN after Tuning to 8 kHz
4-18