The Post-Ipl Procedure; Responding To Mini-Setup Prompts - NEC Express5800/320Ma Software Installation And Configuration Manual

16. A few minutes may pass before the system restarts and the post-IPL procedure
starts.

The Post-IPL Procedure

Perform the post-IPL procedure if Windows and Express5800/320Ma were preinstalled
on your system, or if you have just performed the IPL procedure.
Checklist: Performing the Post-IPL Procedure
If you have not already done so, complete the Mini-Setup Worksheet. See
"Mini-Setup Worksheet" on page
Respond to Mini-Setup prompts. See
page 2-9.
Complete the post-IPL procedure. See
page 2-10.

Responding to Mini-Setup Prompts

1. If you have just performed the IPL procedure, go to step 2. Otherwise:
a. Insert the disk that contains the boot partition in the following location:
– In a rack-mountable system, in the bottom-most slot in the top enclosure
– In a pedestal system, in the enclosure on the left, in its right-most slot
b. Turn on the system, if you have not already done so. See
Procedure" on page
2. If the Welcome to the Windows Setup Wizard starts, respond to the Mini-Setup
prompts. If prompted by Mini-Setup, enter the license key again. (You are not
prompted for the license key if Windows was installed by the manufacturer.) Use
the information you provided in
When Mini-Setup is finished, the system reboots.
N O T E
Before proceeding, check for the latest information about
your system and Express5800/320Ma in the Release
Notes: Express5800/320Ma on the NEC ExpressBuilder
CD (2 of 2) shipped with your system.
2-6.
N O T E
If your system contains VTMs, the mouse and keyboard
may appear unresponsive at some point after the system
2-3.
"Responding to Mini-Setup Prompts" on
"Completing the Post-IPL Procedure" on
Table 2-1 to respond to these prompts.
Installing Express5800/320Ma System Software
The Post-IPL Procedure
"Performing the IPL
2-9