Installing Documentation For Express5800/320Ma Systems - NEC Express5800/320Ma Software Installation And Configuration Manual

Installing Documentation for Express5800/320Ma Systems

2. Express5800/320Ma software RMI automatically runs.
If Express5800/320Ma software RMI does not automatically run when you insert
the CD, on the Windows task bar, click Start and then Run. Substituting the drive
letter of your CD-ROM drive for D, type the following command:
D:\bin\setup.hta
3. Follow the prompts to run the Express5800/320Ma software RMI Readiness Test,
which determines whether your system has the necessary conditions for installing
remote-management software for Express5800/320Ma systems. If the system
passes the test, go to step 4.
If the system fails the test, click View Log on the Readiness Test Failed dialog
box to examine the results of the test. Then perform the necessary tasks to correct
the situation and run the Express5800/320Ma Software RMI Readiness Test again.
4. When the Readiness Test Passed dialog box appears, follow the prompts to install
remote-management software for Express5800/320Ma systems.
You can accept the default settings for any third-party software installed.
Installing Documentation for Express5800/320Ma Systems
The installation lets you install model-specific versions of the documentation on a PC.
Before you install the documentation, make sure that:
•
You have the ExpressBuilder CD (2 of 2) for Express5800/320Ma systems
available.
•
The system disk has approximately 60 MB of space available for each
documentation set.
•
Microsoft Internet Explorer
cookie support are enabled in the browser.
5-2 Express5800/320Ma: Software Installation and Configuration Guide
®
is the default browser, and both JavaScript™ and