Enabling And Disabling Autoburn To Vtms - NEC Express5800/320Ma Software Installation And Configuration Manual

•
FW Update
•
Firmware Update Complete
•
Primary or Secondary
9. When the value of the OpState:State property is Primary, the firmware update
process updates the second VTM. To monitor the progress of the firmware update
of the second VTM, select it in ftSMC.

Enabling and Disabling Autoburn to VTMs

Autoburn ensures that the firmware on the VTM is the same revision as that of the file
on the system disk. After the CD-ROM copies the VTM firmware to the system disk, the
system automatically burns the firmware if you reboot the system, or if certain events
occur to the VTM that cause it to change its state (a rare occurrence).
Autoburn does not occur if you download the firmware file. However, if you manually
update the firmware on the VTMs, autoburn ensures that the VTMs stay at that revision
until you burn another revision or use the CD-ROM to copy the firmware to the disk.
By default, autoburn is enabled.
N O T E
After the firmware is updated, the VTM is rebooted.
Rebooting the VTM may take several minutes, during
which time the Update Firmware action is not available on
the context menu for either of the VTMs. When the reboot
is complete, the value of the OpState:State property is
Primary or Secondary.
Updating VTM Firmware
Updating Firmware 6-3