Reloading Express5800/320Ma Software - NEC Express5800/320Ma Software Installation And Configuration Manual

Reloading Express5800/320Ma Software

•
Make sure you have the following media available:
– ExpressBuilder CD (1 of 2)
– ExpressBuilder CD (2 of 2)
– Backup media, if you are performing a disaster recovery and can back up the
system, or have a backup from which you can restore data
Reloading Express5800/320Ma Software
1. Do one of the following:
•
Browse to a local network share that contains the contents of the
Express5800/320Ma ExpressBuilder CD (1 of 2). Open the bin folder and
double-click Setup.hta.
•
Insert the Express5800/320Ma ExpressBuilder CD (1 of 2) into the CD-ROM
drive in the enclosure whose power button LED is green-lit.
2. The Express5800/320Ma software reload procedure automatically runs.
If the Express5800/320Ma software reload procedure does not automatically run
when you insert the CD, on the Windows task bar, click Start and then Run.
Substituting the drive letter of your CD-ROM drive for D, type the following
command:
D:\bin\setup.hta
3. Follow the prompts to run the reload readiness test, which determines whether
your system has the necessary conditions for reinstalling Express5800/320Ma
software. If the system passes the test, go to step 4.
4-2 Express5800/320Ma: Software Installation and Configuration Guide
N O T E S
1. If, at any point during the reload procedure, a dialog
box appears with the message The Target file
exists and is newer than the source, click
Continue.
2. During the reload procedure, the Progress dialog
boxes may obscure other dialog boxes. If the reload
procedure appears stalled, move the Progress dialog
box and check for a message box that requires you to
click OK.