Inch Hard Disk Drive - NEC Express5800/R120b-1 User Manual

Installation
Take the following steps to install a hard disk drive. This procedure applies to all the hard disk drive
bays. See the next section for the procedure installing a hard disk drive in the flex bay.
NOTE: Any hard disk drive can be installed or removed in or from the
server only by removing the front bezel.
IMPORTANT:
In the RAID System, use the hard disk drives having the same specification
including the capacity.
Do not press the POWER switch during the installation or removal of the hard
disk drive if your server is running.

2.5-inch hard disk drive

1.
See page 9-4 to prepare.
2.
Locate the slot in which you are going to install a hard disk drive.
The server has six slots. Fill the vacant slots with hard disk drives from the lower port
number (as described in "3.5 inch hard disk drive" on page 9-7).
3.
Remove the dummy tray.
There are dummy trays in all hard disk drive bays.
IMPORTANT:
Keep the dummy tray for future use.
The purpose of a dummy tray is to increase the cooling effect in the server. Install
a dummy tray in slots not containing a hard disk drive.
4.
Unlock the hard disk drive handle.
Upgrading Your Server 9-9