9-60 Upgrading Your Server
Installing Additional Battery for RAID Controller
Take the following steps to install an additional battery for RAID controller.
2.5-inch disk model
1.
See page 9-4 to prepare.
2.
Pull out the server from the rack (as described on page 9-4).
3.
Remove the top cover (as described on page 9-24).
4.
Remove the riser card.
IMPORTANT:
any other components.
5.
Disconnect cables from the RAID controller.
6.
Remove screws from the RAID controller, and then remove the RAID controller.
Carefully remove the riser card so as not to contact
Screws