Additional Battery Unit for RAID Controller
Take the following steps to install an additional battery to RAID Controller (N8103-129/130).
Installation
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Remove the left side cover, and open the front mask.
3.
Remove the RAID Controller, and install the battery connection board that comes with
additional battery to the RAID Controller.
See the removal procedure of PCI board for how to remove the RAID Controller.
4.
Connect the cable to the battery connection board.
Make sure the markings on connector and that on the cable.
Upgrading Your Server 9-69