NEC Express5800 User Manual page 397

6.
Push the 5.25-inch device to the device bay carefully.
NOTE:
Make sure that the cables are not caught while the 5.25-inch
device is pushed into the slot.
IMPORTANT:
inserted easily, push the device to the slots with it lifted a little.
7.
Fix the rails by using the screws removed in step 3.
Single-height device
8.
Check whether the installed 5.25-inch device is projected too much from the front of the
server.
Check the device installed in a 5.25-inch device bay based on the factory-installed optical
disk drive.
9.
Connect the interface and power cables to the 5.25-inch device installed from the left side
of the server.
See Chapter 10 for cable connection.
IMPORTANT:
cause a malfunction to occur. Provide the connection securely watching
the 5.25-inch device and cable connectors.
NOTE:
Make sure that the cable is not caught.
10.
Install the removed components.
11.
Setup the SCSI BIOS for the SCSI device according to the manual that comes with the
SCSI controller.
12.
Install the device driver according to the manual that comes with the device.
If a 5.25-inch device occupying two slots cannot be
Connector pin bending or incomplete connection may
Upgrading Your Server 9-59
Double-height device